|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
09-28-2021, 02:04 PM | #1 |
Not Yet Wild
Join Date: Nov 2019
Posts: 2
|
motor grommet/bushing
2002 Yamaha G19 with D&D motor and controller. Was having increasingly loud whining noise on acceleration and deceleration, and found that the input shaft bearing (not the sealed one) is worn badly. New input shaft kit on order and was wondering if I should go ahead and install the rubber grommet/bushing between the input shaft and motor while I have the motor off, even if that wasn't the cause of the noise. It didn't have one when I took the motor off.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Use Armature bushing on new motor? Spline grease? | Electric Yamaha | |||
Spline Grommet?? Motor Bumper??? | Electric Yamaha | |||
Pedal Box Grommet | Electric EZGO | |||
Motor spline bushing/spacer? | Electric EZGO | |||
Club Car electric motor bushing | Electric Club Car |