![]() |
![]() |
#1 |
Not Yet Wild
![]() Join Date: May 2010
Location: East Petersburg,PA
Posts: 21
|
![]() When I bought the cart I noticed the one rear axle nut was loose to I torqued it to 90ft. Lbs. and after a few miles I noticed it is loose again what holds the rear axle in so I have an idea of what to look at being worn.
|
![]() |
![]() |
![]() |
|
![]() __________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
![]() |
#2 |
Happy Carting
![]() ![]() Join Date: Dec 2007
Location: Southern California
Posts: 71,346
|
![]() You do have the cotter pin in ... right? C clips retain the bearing on the axle .... Go for bearings, Seals and new C clips
![]() |
![]() |
![]() |
![]() |
#3 |
Not Yet Wild
![]() Join Date: May 2010
Location: East Petersburg,PA
Posts: 21
|
![]() Thanks, Cotter pin was installed still came loose.
|
![]() |
![]() |
![]() |
#4 |
Happy Carting
![]() ![]() Join Date: Dec 2007
Location: Southern California
Posts: 71,346
|
![]() When you jack the cart up and remove the tire, does the axle move in and out when you pull and push on it? No? Make sure the brakes are not holding the drum.......
|
![]() |
![]() |
![]() |
#5 |
Not Yet Wild
![]() Join Date: May 2010
Location: East Petersburg,PA
Posts: 21
|
![]() The brakes aren't dragging, will have to check on the axle movement tomorrow going to disassemble then.
|
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
EZGO rear axle exploded diagram | Gas EZGO | |||
WTB Gas EZGO rear trans-axle | Golf Carts and Parts | |||
W T B rear axle tubes for 97 ezgo | Golf Carts and Parts | |||
94 ezgo + older rear axle | Electric EZGO |