04 txt input shaft seal part#

[Twizted]

I searched around and could not seem to find this info. Does anyone know the part number or numbers needed to replace the seal on the input shaft of a 04 36v txt? I pulled the motor to send to plum and it is all caked up in there so I assume it is in need of a seal around the shaft. I have found some info saying you can just replace the seal and others saying the seal is the bearing. Any help would be gratefully appreciated.

[ojo]

On my RXV there is a input shaft seal, on TXT model there is only one found for the gas version, electric seems to have an o-ring and a sealed bearing on motor side.

[Twizted]

Originally Posted by ojo

On my RXV there is a input shaft seal, on TXT model there is only one found for the gas version, electric seems to have an o-ring and a sealed bearing on motor side.

Yes and either way I hope it's as easy as removing a snap ring and taking out bearing and/or seal on that side. Hopefully, someone has part numbers and guidance. I was told by PQ that it could damage the rebuilt motor if it gets oil into it...

[kgsc]

23519G1 Is Ezgo number. 6005LL

[Twizted]

Originally Posted by kgsc

23519G1 Is Ezgo number. 6005LL

Are there any other parts that need to go with it? Are those bearing press fit on the input shaft and will the shaft just pull out without retaining ring in there?

[kgsc]

C clip holds the shaft in and yes it is pressed on. Should be able to pull it out by twisting

[Twizted]

Originally Posted by kgsc

C clip holds the shaft in and yes it is pressed on. Should be able to pull it out by twisting

Thanks so much!

[kgsc]

If you go look on country cat’s website you can find the breakdown of that axle.

Here https://www.countrycat.com/arctic-ca...G01%7c%7eA-1/y