|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-27-2014, 08:51 AM | #11 |
Not Yet Wild
Join Date: Nov 2013
Location: BURLESON, TX
Posts: 50
|
Re: 2006 PDS cart
I an not getting continuity but my multi meter is making the reverse beeper go off,no matter which of the 2 wires I touch
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-27-2014, 08:53 AM | #12 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 2006 PDS cart
It is not uncommon for the rocker switch to corrode or go bad.
Double check the continuity test. If it still fails remove the switch from the dash. With the cart on jack stands Pull the keyswitch plate and inspect the 3 rocker switch connections for corrosion. If needed clean and re test. If clean remove the top wire and hold it in contact with the center wire and see if the wheels turn. Then do the same test with the bottom wire. If the wheels turn in both directions when manually connected but not when switched - replace the switch. |
08-27-2014, 09:11 AM | #13 |
Not Yet Wild
Join Date: Nov 2013
Location: BURLESON, TX
Posts: 50
|
Re: 2006 PDS cart
Ok no continuity that a can detect. But once I touch both of the 2 wires the reverse buzzer goes off.
|
08-27-2014, 09:14 AM | #14 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 2006 PDS cart
Time to remove the switch and test as described above... it may be a dirty connection.
|
08-27-2014, 10:23 AM | #15 |
Not Yet Wild
Join Date: Nov 2013
Location: BURLESON, TX
Posts: 50
|
Re: 2006 PDS cart
After removing and cleaning switch, it is writing and has continuity all the way to the plug on the controller. Now I an getting solenoid driver failure in diagnostic mode.
|
08-27-2014, 10:24 AM | #16 |
Not Yet Wild
Join Date: Nov 2013
Location: BURLESON, TX
Posts: 50
|
Re: 2006 PDS cart
Cart will move if I use jumper from b+ to solenoid on battery side
|
08-27-2014, 11:42 AM | #17 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 2006 PDS cart
You are close ... B+ side of the solenoid activation circuit is supplied by pin 7 in hte main molex connector. Slide the connector up just a bit to get the tester on the pin while the plug is still connected and see if you are getting B+ from pin 7 when you try to go. If no, the controller has failed.
|
08-27-2014, 11:56 AM | #18 |
Not Yet Wild
Join Date: Nov 2013
Location: BURLESON, TX
Posts: 50
|
How would I test this. Am I checking for voltage or continuity?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Return to the Cart World - 2006 CC | Electric Club Car | |||
What can you tell me about this 2006 cart? | Electric EZGO | |||
2006 Fleet Cart Pricing | Electric EZGO | |||
2006 E-Z-Go pds cart fos sale in SC | Golf Carts and Parts | |||
2006 Electric Cart | Electric Club Car |