|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
09-24-2014, 06:38 AM
|
#1 |
|
Getting Wild
Join Date: Jun 2013
Location: Sugar Land, TX
Posts: 131
|
Ezgo txt creeps forward, reverse fine
Starting new thread. ezgo 2003 txt , when in forward it goes slow ,i put it in reverse for 5 seconds rolling then switch it into forward and it goes normal speed , anyone know what it could be?
Pack voltage over 38 Serial number j103/2024549 I'm thinking fnr switch or solenoid. Anyone? Smackdaddy66 |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-24-2014, 06:49 AM
|
#2 |
|
Gone Wild
Join Date: Aug 2014
Location: fletcher,nc
Posts: 601
|
Re: Ezgo txt creeps forward, reverse fine
just guessing but seems like f/r switch to me...look for heat discoloration on the switch and switch board...mine was doing the same thing and i am in process of replacing it now.good luck!
|
|
|
|
|
09-24-2014, 08:32 PM
|
#3 |
|
Gone Wild
 Join Date: Apr 2013
Location: Deep Run, NC
Posts: 2,544
|
If it were the solenoid it would effect both directions. I would guess fnr or bad wire from the FNR.
|
|
|
|
|
09-25-2014, 09:02 AM
|
#4 |
|
Getting Wild
Join Date: Jun 2013
Location: Sugar Land, TX
Posts: 131
|
ImageUploadedByTapatalk1411653668.845439.jpgImageUploadedByTapatalk1411653687.161954.jpg
Well I think this might have something to do with the issue. Pin 5 in 10-pin connector to controller is burned up. What do you think? Smackdaddy66 |
|
|
|
|
09-25-2014, 09:03 AM
|
#5 |
|
Getting Wild
Join Date: Jun 2013
Location: Sugar Land, TX
Posts: 131
|
Btw - where is the FNR switch located? I couldn't find it.
Smackdaddy66 |
|
|
|
|
09-25-2014, 11:30 AM
|
#6 |
|
Gone Wild
Join Date: Apr 2013
Location: Deep Run, NC
Posts: 2,544
|
That looks like a PDS drive. I was thinking series. The FNR should be on the dash.
|
|
|
|
|
09-25-2014, 11:47 AM
|
#7 | |
|
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ezgo txt creeps forward, reverse fine
Quote:
The posters suggesting F/R switch issues probably thought you had a series cart since you didn't fully identify your cart. Call it a 2003 TXT PDS and everybody will be on the same page.  J1 Pin-5 and J1 Pin 4 supply power to the controller for its internal electronics, for the ITS and for the external controls, but I'm not sure which of those two pins supplies power to which circuitry. The burnt connector may be the problem source, but the controller may also be going bad. Pin-5 did get hot enough to damage the molex plug, so the controller was drawing excessive power through Pin-5 and I'm leaning towards a bad controller. |
|
|
|
|
|
09-25-2014, 12:33 PM
|
#8 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: Ezgo txt creeps forward, reverse fine
Repair or replace that wire harness (plug) before you install another (upgraded) control.
 |
|
|
|
|
09-25-2014, 11:25 PM
|
#9 |
|
Getting Wild
Join Date: Jun 2013
Location: Sugar Land, TX
Posts: 131
|
Ordered new controller and harness from our sponsors at fsip! Fingers crossed!
Smackdaddy66 |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| cart creeps forward | Electric EZGO | |||
| 1986 club car 36 volt goes fine in reverse but not in forward | Electric Club Car | |||
| g9 works fine in reverse but grinds when in forward | Gas Yamaha | |||
| PDS - no reverse. Forward is fine. | Electric EZGO | |||
| starter is fine in forward but not in reverse | Gas Harley Davidson | |||
Linear Mode
