|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-07-2019, 02:24 PM | #1 |
Getting Wild
Join Date: Jun 2011
Location: Jacksonville, Florida
Posts: 90
|
schematic and picture wiring don't match
I'm trying to finish up my wiring of a new alltrax controller and of come across a problem where the wires in the schematic are different than a picture that was taken by ScottyB. It's only on solenoid the two main wires the schematic shows the battery pack positive going to side that diode band is on and other comes from alltrax B+. In the picture (see link below) these two wires are swapped so which is right or are they interchangeable. Thanks for any help
http://www.buggiesgonewild.com/elect...install-3.html |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-07-2019, 06:44 PM | #2 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: schematic and picture wiring don't match
The two large terminals connect to the high current contacts and are not polarized on the solenoid shown in the picture.
The two small terminals connect to the solenoid coil and are not polarized on the solenoid shown in the picture. The diode is polarized and the banded end has to connect to the small terminal with the red wires on it. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Gcor wiring harness doesn’t match cart wiring harness | Gas Club Car | |||
02 IQ wiring diagram doesn't match what i have | Electric Club Car | |||
Need fuel pump schematic or picture | Gas EZGO | |||
wiring schematic | Electric EZGO | |||
87' G2 wiring schematic | Gas Yamaha |