|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-19-2014, 10:19 AM | #1 |
Gone Wild
Join Date: Mar 2014
Location: S.W. Florida
Posts: 302
|
input shaft
I was wondering can I just replace the outer bearing & seal on my input shaft it has a little play up & down doesn't move in or out. is their another bearing on the other end of the shaft in side the case?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-19-2014, 02:50 PM | #2 |
Gone Wild
Join Date: Mar 2014
Location: S.W. Florida
Posts: 302
|
Re: input shaft
no one has just done the bearing you all do the input shaft kit for $300
|
06-19-2014, 06:39 PM | #3 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,875
|
Re: input shaft
Yes you can change just the bearing and seal, but you also need to order a new gasket, that gasket (tolerance wise) is critical.
|
06-20-2014, 12:28 PM | #4 |
Gone Wild
Join Date: Mar 2014
Location: S.W. Florida
Posts: 302
|
Re: input shaft
you are referring to the gasket where the case comes apart?? I planed on it any ways. thanks. there is only 1 bearing on the input shaft correct
|
06-20-2014, 06:34 PM | #5 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,875
|
Re: input shaft
Yes, that gasket. There is also a bearing on the inward side of the input shaft, but more then likely it should be fine. Rember, you must take out the set screw/spring and ball bearing (for the shifter shaft) out first. A short flat headed screw driver will work, then a magnet for the spring and ball bearing. If you lucky, the side case will come off with the input shaft and f/r gear assy intacked. Then just remove the "spirrel clip" holding on the idler gear, then tap out the old breang and seal and install the new one's. Good luck.
|
06-20-2014, 09:13 PM | #6 |
Gone Wild
Join Date: Mar 2014
Location: S.W. Florida
Posts: 302
|
Re: input shaft
thanks for the help
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G2 Input shaft | Gas Yamaha | |||
Input shaft | Electric EZGO | |||
G16 input shaft | Gas Yamaha | |||
G9 Input Shaft? | Gas Yamaha | |||
need input shaft for G2 | Golf Carts and Parts |