Rewire issues

[mulletman87]

looking for some help, I have a 99 ezgo that had a fire last fall And im trying to finish up the wiring on it. I have the wiring diagrams but Im having a hard time with them, so this is what I need.
The fire started at the forward/reverse switch, I have replaced it with a heavy duty one. The majority of wires were still connected so I was able to replace those ones without an issue, but a few were not and i want to make sure I get them right.
First one is the orange wire that comes out of the computer (not sure if thats its name) but a cylonoid is attached to it. Where does that wire go ?
Second one is on that cylonoid there is two black wires, one of them goes back up to the top of the computer to a wire that goes to the motor, but where does the second black wire from the cylonoid go?
Third one, the wires that comes from the charging wire harness black, white and red, I know where the black and white one go but where does the red one go?
Last one is the wires comming from the key switch, green and blue, looks like the green one went with a green one from the computer, but where does the blue one go?
There are three tabs that are open on the forward reverse switch, please explain it if im am looking at the front of the switch and go from left to right.
Thank you for any help that you can give.

[PuttPutt]

Not sure this will help. Attached 1995 to 2010 wire diagram.

[PuttPutt]

aug 2011 thats an old post.

[yurtle]

Originally Posted by PuttPutt

aug 2011 thats an old post.

The post was Yesterday 01:20 PM. August 2011 was when the poster joined our community.

[PuttPutt]

Originally Posted by yurtle

The post was Yesterday 01:20 PM. August 2011 was when the poster joined our community.

[scottyb]

It's all good. Thanks for helping out an BGW member Put.

[mulletman87]

Okay I have this wire diagram, The problem is I can trace the wires from the controler to the reverse switch, but am having a problem with looking at the picture and trying to determine if that is the top of the switch or bottom. for example the black wire from the silonoid (a2) goes to the switch but where? I can see the letter C but what does that stand for?

[yurtle]

Originally Posted by PuttPutt

Don't be , I just wanted to point out where the age was.

FWIW,
When you see threads in bold letters, it means one or more of the posts haven't been read by you yet. Sometimes very old posts spring back to life, often by a comment someone has after doing a search. It's a handy thing to notice, as folks often come and go, and may not still be around months or years later.

In your case, you replied to a fresh post, which is fine.

[PuttPutt]

This is from a 2001 manual. A is at the top then clockwise B, C, D.
Hope it helps.

[mulletman87]

Thank You very much PuttPutt, That picture makes sense.