2005 ez no go

[HarleyOne]

i have a 2005 ezgo pds cart with fresh trojans and the problem is it was running fine and all of a sudden it stopped I can go out some days and it will run for a little and other day it wont hit a lick. I can hear the solinoid ckick but it still wont move any help would be greatful



thanks Harley

[JohnnieB]

The solenoid is clicking narrows it down a bit, but not much.

Could be a bad ITS sensor or worn insulation of the field cables.
Could also be a bad cable or connection in the High Current loop, or bad solenoid contacts, or bad motor, or bad controller.

Connect a DVM between the B- and A1 terminals on the controller.
Before the solenoid clicks, you should have about 3-5 volts less than pack voltage.
When pedal is pushed just far enough for solenoid to click, you should have FULL pack voltage.
As pedal is pushed further, the voltage should decrease, reaching Zero when pedal is on floor.

Also, put controller in diagnostic mode and it might give you an error code. The text at the bottom of the attached label tells you how to get into diagnostic mode.

[HarleyOne]

Thanks for your help ill let you know the status later in the week when I have a chance to check things out