|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-10-2010, 08:36 AM | #1 |
Not Yet Wild
Join Date: May 2010
Location: MASS
Posts: 17
|
Electrical Problem
I just replaced the solenoid with a new factory replacement because i was affraid it was sending voltage back through the system causing the wires to smoke and become hot. I replaced that and rewired what i thought was the proper system but for some reason, with the key on and directional switch in forward the cart fries the little micro switch in the footbox at the hit of the throttle pedal. The cart is a 2000 series 36 volt. If some one could send me a picture of their existing wiring on their cart that be great just cause these **** diagrams keep either screwing me up or i think theres just something simply wrong.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-11-2010, 06:34 AM | #2 |
Gone Wild
Join Date: Aug 2008
Location: Cumming, GA
Posts: 313
|
Re: Electrical Problem
Did you remove the diode on the orignal solenoid? If so you probably installed it backwards. The silver band on the diode goes on the small solenoid post with the yellow wire.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
EZ-Go electrical problem | Electric EZGO | |||
Electrical Problem?? | Electric EZGO | |||
Electrical Problem | Gas EZGO | |||
EZ-GO Electrical Problem | Electric EZGO | |||
Electrical Problem | Electric Club Car |