|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
08-03-2013, 07:59 PM
|
#1 |
|
Not Yet Wild
Join Date: Jun 2013
Location: Lubbock,Texas
Posts: 28
|
CC 2010 overweight limit burned up motor
New to this so please bear with me, I work at custom cart shop and owner brought in a cc2010 model that some big women were on,burned out the motor, well he had replaced motor,solenoid,controller,comp. and pedal assembly and still no go. Has full charge, after some searching on the motor cont. output I had voltage on two of the three wires put the connector back and was able to move the cart but only in one direction, if I changed direction it would not run until I unplugged the three wire connector and check the voltages again.....
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
08-03-2013, 09:29 PM
|
#2 | |
|
ΜΟΛΩΝ ΛΑΒΕ
 Join Date: Nov 2012
Location: West Virginia
Posts: 4,094
|
Re: CC 2010 overweight limit burned up motor
Quote:
 When you say big, you must not be kidding!!  Someone will be along with more experience in newer carts shortly but for now, welcome to BGW! |
|
|
|
|
|
08-03-2013, 10:46 PM
|
#3 |
|
Gone Wild
Join Date: Aug 2009
Posts: 14,245
|
Re: CC 2010 overweight limit burned up motor
Wow, I have never heard of a cart burning up due to heavy women!
I would bet a wire somewhere is not hooked up right, since basically every electrical component is brand new. Check and double check your wiring. |
|
|
|
|
08-04-2013, 04:36 AM
|
#4 |
|
Medicare Recipient
Join Date: Jun 2011
Location: West Michigan
Posts: 3,541
|
Re: CC 2010 overweight limit burned up motor
. . . reminds me of a song by Queen . . .
|
|
|
|
|
08-04-2013, 06:38 AM
|
#5 |
|
Gone Wild
Join Date: Sep 2012
Location: Savannah, GA
Posts: 2,760
|
Re: CC 2010 overweight limit burned up motor
Sounds like someone used the "shotgun troubleshooting" method and failed. Download a wire diagram and use a DVM, you will find your problem.
|
|
|
|
|
08-04-2013, 05:35 PM
|
#6 |
|
Not Yet Wild
Join Date: Jun 2013
Location: Lubbock,Texas
Posts: 28
|
Re: CC 2010 overweight limit burned up motor
I will not lie,,,yes he said they were 2 VERY OVER THE WEIGHT limit , good thing it's a lifted cart, still I think would have rather ran cart in lake claimed insurance......lolololo
I have wiring and DMV, also checked batteries with load tester, last thing I need is to double check the wiring for melted wires or missed connections. |
|
|
|
|
08-14-2013, 05:47 PM
|
#7 |
|
Not Yet Wild
Join Date: Jun 2013
Location: Lubbock,Texas
Posts: 28
|
Re: CC 2010 overweight limit burned up motor
OK guys ...checked wiring and all is correct. Using our meter to check settings on the controller, I find in the monitor mode , it shows that the pedal is pushed at 48%, I am assuming this is a problem since I have checked another cart and it shows 0%. I have changed the whole pedal assembly with no change...
|
|
|
|
|
08-14-2013, 07:38 PM
|
#8 |
|
72 volt torque monster
Join Date: Dec 2009
Location: Sorrento, FLA
Posts: 589
|
Re: CC 2010 overweight limit burned up motor
sounds like the controller throttle input is set at 0-5k, where it should be 5k-0
 |
|
|
|
|
08-14-2013, 08:58 PM
|
#9 |
|
Not Yet Wild
Join Date: Jun 2013
Location: Lubbock,Texas
Posts: 28
|
Re: CC 2010 overweight limit burned up motor
I can change this setting with the meters menu?
|
|
|
|
|
08-14-2013, 09:22 PM
|
#10 |
|
Gone Wild
Join Date: Aug 2009
Posts: 14,245
|
Re: CC 2010 overweight limit burned up motor
If its an alltrax you can hook it to a computer and change the settings.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Mechanic says motor burned up??? | Electric Club Car | |||
| Motor Burned down 05 PDS | Electric EZGO | |||
| Motor Limit - Downhill Speed | Electric Club Car | |||
| Motor burned out | Electric golf carts | |||
| Burned up motor? | Electric EZGO | |||
Linear Mode
