|
|
|
09-02-2014, 01:28 PM
|
#1 |
|
Not Yet Wild
Join Date: Sep 2010
Location: New Jersey
Posts: 16
|
burned up my controller dcx300R7
My fairplay ZX 4.0 -6P was reversing out of shed and the controller started to smoke up. What would cause the controller to burn up? aren't these protected by solenoid/resistor? It had the stock dcx300R7.
|
|
|
|
09-02-2014, 02:57 PM
|
#2 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 72,362
|
Re: burned up my controller dcx300R7
The resistor and diode do not protect against catastrophic errors. Typically in Sepex drive carts 3 things cause the controller to burn up. A direct short on the input or the output side. Overload or excess amperage draw. Motor failure.
Had a guy tell me his DCX control failed so he put the old stock control back in, 100 yds later the motor failed on the reduced stock control... |
|
|
|
|
09-03-2014, 10:27 AM
|
#3 |
|
Not Yet Wild
Join Date: Sep 2010
Location: New Jersey
Posts: 16
|
Re: burned up my controller dcx300R7
thank you for the response I'll check the motor out, its only a year old motor so Im hoping it's not dead. What would cause and overload or excess amperage? batteries are also 1 year old 8 x 6 volt setup.
|
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Burned controller -- Can you ID this IC OR Resistor? | Electric EZGO | |||
| Burned OBC? | Electric Club Car | |||
| Burned connection to key | Electric EZGO | |||
| 2001 EZGO / PDS burned up motor and controller | Electric EZGO | |||
| 91 DS wont run after controller burned up | Electric Club Car | |||
Hybrid Mode