FSIP speed motor install TXT48

[scottyb]

By the way I set the rev limit at 6500 and on 18 inch tires I hit 27.5 with authority - with 20 inch tires I would have been over 30.

I was just talking with wheels about having a temp gauge made to suit us. I anticipate the end of summer arrival. As a promotion I will be sending one out with every motor when they do arrive...... but for now we gotta make due with the mish-mosh on amazon.

[wheelnsniper]

Originally Posted by scottyb

By the way I set the rev limit at 6500 and on 18 inch tires I hit 27.5 with authority - with 20 inch tires I would have been over 30.

I was just talking with wheels about having a temp gauge made to suit us. I anticipate the end of summer arrival. As a promotion I will be sending one out with every motor when they do arrive...... but for now we gotta make due with the mish-mosh on amazon.

Exactly what I needed to see. Robbie was saying something about the pigtail and if the TXT had it or not. If it didn't to not worry about connecting but if it did I would probably have to but connect to match plugs. Guess I will have to do that. This helps a lot. Again thanks Scotty. I will see what I can do for I write up of the PQ install

[scottyb]

Looking forward to the PQ results. On mine I cut the OEM pigtail and soldered. I shrink wrapped each little wire then put a bigger adhesive lined shrink tube over all 3. It seems good enough for forever. I see no reason to ever change this motor. I will put a temp sensor on it as we discussed in the emails.

[Raystar57]

Nice brush and access port!
I got my eye on this motor for my DS.

[scottyb]

Yes, and the bolts have good access and long shoulders. I like the main terminals are female - unlike studs that can get damaged in shipping.
I was pretty impressed on the street last night

[yurtle]

I like female "bolts" as well. My next set of batteries will have different bolt options, as I like the thought of not having to worry about over-tightening the bolts on embedded studs.

[mjroman20]

Originally Posted by mgray70

Do they make a series motor? FSIP

Sent from my SM-G930R4 using Tapatalk

No, just shunt (sepex) motors for the time being.

[agpfl]

Scotty, I know they make 36v PDS version, but will this work in an upgraded 48v PDS cart? Do you know the min. voltage? I have one of the Lithium packs that I operate from 50v all the way down to 40v.

[scottyb]

Originally Posted by agpfl

Scotty, I know they make 36v PDS version, but will this work in an upgraded 48v PDS cart? Do you know the min. voltage? I have one of the Lithium packs that I operate from 50v all the way down to 40v.

Essentially all the TXT48 is is a 48v version PDS. So I don't see why you could not run the same set up I have here with the XCT for PDS on 50-40v

[agpfl]

I just worry about the lower voltage side of it. Would I damage the motor by not feed enough volts? Would there be any adverse side effects to the Alltrax controller?

Sent from my SCH-I545 using Tapatalk