|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-04-2019, 10:23 AM | #1 |
Not Yet Wild
Join Date: Aug 2019
Posts: 2
|
Ergo speed control
1998 ergo freedom, I only get 4.1 volts out my speed control when I test the controller. Is it a bad controller. Batteries fully charged
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-04-2019, 12:18 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: Ergo speed control
In order to test a speed controller output verify the throttle signal input is correct, and the solenoid is working properly, then verify the controller has power to the control board and lastly check for output.
Which drive system are you asking about? Not sure? Go here to find out > https://www.cartsunlimited.net/upgrade-suggestions.html |
08-05-2019, 07:40 PM | #3 |
Not Yet Wild
Join Date: Aug 2019
Posts: 2
|
Re: Ergo speed control
I have a series 1998. New solenoid and batteries are all good
Just had motor check out and new brushes put in. I’m not sure If it the controller or f/r switch. When I test the controller from M to B+ it reads 4.1v with accelerate pushed all the way down. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Ergo elect. Speed issue | Electric EZGO | |||
82 EZ-Go speed control | Electric EZGO | |||
Speed control | Electric Club Car | |||
speed control? | Electric EZGO | |||
more speed without sacrificing low speed control | Gas Club Car |