|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
08-23-2022, 11:51 AM
|
#1 |
|
Not Yet Wild
Join Date: Mar 2020
Posts: 12
|
36v metalist wont move
94 36v metalist had a lug burn up on the f/r panel a month or so ago. Has ran fine until two days ago. My son was riding it and it just quit. Solenoid clicks when pressing the pedal. All the voltage stuff checked out with it and the controller. Other than the fact my meter was reading 46-48 volts. Pretty sure it’s a meter issue. Would a a bad f/r switch cause it not to move at all? I have the same voltage a motor with the solenoid open. Pretty much stumped at this point. I’m leaning towards the f/r just because I know it got burnt some but has been fine for a month or better.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
08-23-2022, 03:21 PM
|
#2 |
|
Gone Wild
 Join Date: Jan 2013
Location: Saint Petersburg, FL
Posts: 2,089
|
Re: 36v metalist wont move
Check your meter first. We've seen a weak battery in the meter cause all sorts of bad diagnostics. If your battery is low replace that then go back and check your V. It may be a very different story.
|
|
|
|
|
08-23-2022, 04:47 PM
|
#3 |
|
Gone Wild
Join Date: Jul 2015
Location: Central South Carolina
Posts: 939
|
Re: 36v metalist wont move
I'm betting on the F/R switch. All too often I've won that bet. They just aren't designed to handle the load. Instead of making the main board out of bakelite plastic they should mold them out of porcelain that won't melt.
|
|
|
|
|
08-23-2022, 09:14 PM
|
#4 |
|
Not Yet Wild
Join Date: Mar 2020
Posts: 12
|
Re: 36v metalist wont move
Would I need the whole switch or could I get by with just new studs and the cam switch?
|
|
|
|
|
08-23-2022, 10:07 PM
|
#5 | |
|
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: 36v metalist wont move
Quote:
you would have to take it apart and see how bad it is if anything's melted or not to answer that question |
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Wont stop beeping and wont move | Electric EZGO | |||
| G22 wont move!! | Electric Yamaha | |||
| 96 club car ds solenoid wont click and cart wont move unless you jump solenoid | Electric Club Car | |||
| 1994 Metalist won't move forward or backward | Electric EZGO | |||
| Ezgo dcs solenoid clicks but wont disengage and wont move | Electric EZGO | |||
Linear Mode
