PDS with Freedom chip...Only hear 2 beeps meaning Steep Hill chip?

[RichardP]

I have a 2008 EZ GO PDS. Bought a freedom chip. Wiring on freedom chip matches freedom chip diagram I have seen in other threads on this forum. Only hear 2 beeps when I toggle N to R 5 times. So I assume the step hill chip is what cart thinks it has?? Any thoughts?? I do not have a clue how many mph cart runs cause I have not hooked a GPS to it yet. I live on a hill and really can't tell any difference with chip or without chip.
Back up alarm did NOT work when I got cart. Wiring was hooked up so I bought a new back up alarm assuming alarm was bad. New alarm sounds very weak unless I put something in the hole. Then it is loud. I know this is opposite of what I have read on here about putting ear plug in hole to make it quieter.

[JohnnieB]

Two beeps means controller is in "Steep Hill" mode.

Put Run/Tow switch into Tow, pull the "Freedom Chip" and measure between the pins.
Should be shorted between 1&5 and 2&3.

While you've got the chip out, put Run/Tow switch into Run and put into diagnostic mode.
How many beeps?
Should be just one for "All Terrain" mode.

Here's the J2 chart.