07 TXT will not move and no reverse buzzer

[lawnripper]

thanks Yurtle.

all cart parts disconnected. cart lifted off ground

so I would follow the diagram...

I would 1st connect pos cable from battery pos to motor A2 and connect the jumper cable between A2 and F2.

then connect the neg cable ( with a bolt on the end) from neg post of battery
connect the part of the neg cable (with another bolt on its end) to the motor A1 post and a jumper from A1 to F1

the touch the two bolts together on the neg cable?

can I use 10 guage electrical cable that we use in our house?

[yurtle]

Originally Posted by lawnripper

thanks Yurtle.

all cart parts disconnected. cart lifted off ground

so I would follow the diagram...

I would 1st connect pos cable from battery pos to motor A2 and connect the jumper cable between A2 and F2. Yep.

then connect the neg cable ( with a bolt on the end) from neg post of battery Cable goes from Battery negative to a bolt. Nothing connected to bolt.
connect the part of the neg cable (with another bolt on its end) to the motor A1 post and a jumper from A1 to F1 Cable from B- to bolt. Another cable from another bolt to A1 & F1.

the touch the two bolts together on the neg cable? Yep.

can I use 10 guage electrical cable that we use in our house? Sure. It's a quick momentary test. It either works or it doesn't.

Replies have to be after "[/QUOTE]", or it says "message too short".

[lawnripper]

rad thank you!

So when I lifted up the rear drivers side and spun the wheel .. i touched the motor.. was I only feeling the input shaft spin or was I feeling the motor spin as well? If I felt the motor spinning that would mean nothing is corroded together correct? but does not mean the motor is working?

[lawnripper]

I tried the motor test.. used my older set of battery cables.
I think the motor works.. but I hear scraping or non smooth spinning.. motor or wheels or and brakes? I took a vid but couldn't figure out how to load it.

Thanks again everyone for all the help !!