|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-29-2016, 11:43 PM | #11 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: RXV Front End Clunk
I use "anti-seize" on all the tubes. I have also found some of them to be too long, allowing too much up-down travel (ezgo will never admit this). I have shortened a few of them. I grind little-by-little & re-test fit them often during the process. I be sure to completely cool them to room temp when i test fit them, as they are longer when they are hot than when they are cold. I will admit i have cut a couple too-short by checking them while still warm.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-02-2016, 11:34 AM | #12 | |
Not Yet Wild
Join Date: Nov 2014
Location: Seal Beach, Ca
Posts: 5
|
Re: RXV Front End Clunk
Quote:
|
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
clunk noise when starting | Gas Club Car | |||
Who'd-a-thunk (clunk) | Gas EZGO | |||
EZ Go Rear Clunk - What to do? | Electric EZGO | |||
82 G1 starting to clunk | Gas Yamaha |