|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-22-2019, 06:17 PM | #1 |
Not Yet Wild
Join Date: Jul 2019
Location: Corralitos Ca.
Posts: 13
|
Ezgo TXT 36v PDS electrical issue
No voltage reading on leads to old 2 pin ignition switch. Switch still works, just no volt reading. Should the switch be replaced?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-22-2019, 09:55 PM | #2 |
Gone Wild
Join Date: Sep 2016
Location: Northern California
Posts: 1,300
|
Re: Ezgo TXT 36v PDS electrical issue
http://www.buggiesgonewild.com/attac...ams-pds36v.jpg
That should be the wiring diagram for your cart. I don’t want to misspeak but it looks like you need pack voltage out to f the reed switch, into pin 4 at j1 on the controller, out of j9 and into your key switch. At least that’s what it looks like to me on that diagram. Johnnieb should see this soon and confirm. Maybe I’m misunderstanding you, but if your key switch tests good, but you don’t have anything going into it, I wouldn’t replace it ??? Hopefully your problem is the reed switch, or a wire, and not the controller. |
07-23-2019, 08:30 AM | #3 |
Not Yet Wild
Join Date: Jul 2019
Location: Corralitos Ca.
Posts: 13
|
Re: Ezgo TXT 36v PDS electrical issue
Thanks Orangeman6 for the info. I'll check it out.
|
07-24-2019, 05:34 PM | #4 |
Not Yet Wild
Join Date: Jul 2019
Location: Corralitos Ca.
Posts: 13
|
Re: Ezgo TXT 36v PDS electrical issue
Checked out my wiring and compaired with wiring diagram. I find my r/w wire from reed switch terminates at j7 and y/w at j3 to key switch. ??? Now what??
|
07-24-2019, 06:08 PM | #5 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Ezgo TXT 36v PDS electrical issue
The wire from the reed switch should go to J1 Pin-4.
I suspect you might be getting the Jack number and the Pin numbers of those jacks a little caddywampus. Here's a picture of a PDS controller with Pin-1 highlighted on the various jacks and a drawing showing the voltage paths through the PDS controller. |
07-26-2019, 03:31 PM | #6 |
Not Yet Wild
Join Date: Jul 2019
Location: Corralitos Ca.
Posts: 13
|
Re: Ezgo TXT 36v PDS electrical issue
Checked wiring again and found r/w wire from reed/s goes to J1 pin 2. y/w goes from J1 pin 8 to key/s. I double and triple checked. Thanks
|
|
|
Similar Threads | ||||
Thread | Forum | |||
EZGO PDS electrical issue | Electric EZGO | |||
EZGO resistor cart electrical issue | Electric EZGO | |||
1998 EZGO Freedom 36V Electrical Issue | Electric EZGO | |||
2002 ezgo 36v electrical issue new batteries hooked up wrong and i blew something? | Electric EZGO | |||
ezgo intermittent electrical issue | Electric EZGO |