Bought a house and in the garage is an ezgo

[sunking]

Originally Posted by plezgo

Batteries are kick 32 volts now. step on the long skinny pedal you can hear it kick like it trying to move but wont roll. I believe I have a drum break hung in the rear.

I seriously doubt that, th ebatteries are just not capable of holding a charge, they are boat anchors.

Real easy to tell. Put the Run/Tow switch in Tow. Now push the cart. If it rolls you know what that means right?

[plezgo]

Talk to me about the run tow switch. Only switch I see on it is the directional forward and rev. lifted seat and dont see where there would be another switch. Am I missing something when I run the serial number it comes up as a 94 textron.

[CCFanatic]

Run/Tow switch should be on the controller cover

[Volt_Ampere]

32 Volts is not going to do it. They are probably dropping to zero when you hit the go pedal.

[scottyb]

Originally Posted by Volt_Ampere

32 Volts is not going to do it. They are probably dropping to zero when you hit the go pedal.

See page 1 my first post = been here done this

Keep trying and it may fry the stock control by pulling high amps at low voltage

[rib33024]

Look at this and see which cart you have, sounds like a marathon or a Medalist to me, is the body metal or plastic


http://www.everythingcarts.com/what-...golf-cart.aspx

[plezgo]

Originally Posted by scottyb

See page 1 my first post = been here done this

Keep trying and it may fry the stock control by pulling high amps at low voltage

sorry some guys it easier to hit with a 2x4, I being one of them.

I went back and reread your first post makes more since now then it did before.

[plezgo]

Originally Posted by rib33024

Look at this and see which cart you have, sounds like a marathon or a Medalist to me, is the body metal or plastic


http://www.everythingcarts.com/what-...golf-cart.aspx

Its a plastic body and by looking at the pictures I would say its a Medalist.

[scottyb]

Originally Posted by plezgo

Its a plastic body and by looking at the pictures I would say its a Medalist.

All medalist had a metal body, You have a TXT, what are the last 2 digits of the manufacture code? Not the serial #, the last 2 digits of the manufacture code
M A N U Facture code.

Did I hit hard enough

[plezgo]

Sure..
Its all plasic give mea little bit and I will see if I can post pictures
A2895