rebuilt starter now running backwards

papastools · 07-11-2019, 05:38 PM

I put new brushes and sanded the armature. Everything look very good but I did not mark the wires where they came from. I found some info on line that put the jumper wire F1 to A2. A1 neg and F2 pos. This spins the motor ccw on the pulley end of the starter. The gas engine has an arrow on it that shows it needs to spin cw. I get a lot of load barking out the intake so bad I can not hold my hand over it. I opened the valve cover and it look like the valve were working normally and not being held open as I first thought.

BearsFan315 · 07-11-2019, 05:47 PM

per what i read on here, you can change rotation on the starter via swapping wires on A1 and A2 terminals

do a search on here, been discussed a few times especially with the cw/ccw club cars !!

main concern is wear on brushes if they have been running and worn in one direction

Fairtax4me · 07-11-2019, 05:56 PM

Need to move the green wire to A1 - F1.
Negative to A2.

Wire diagrams here:

07-11-2019, 05:38 PM	#1
papastools Not Yet Wild Join Date: Aug 2018 Posts: 5	rebuilt starter now running backwards I put new brushes and sanded the armature. Everything look very good but I did not mark the wires where they came from. I found some info on line that put the jumper wire F1 to A2. A1 neg and F2 pos. This spins the motor ccw on the pulley end of the starter. The gas engine has an arrow on it that shows it needs to spin cw. I get a lot of load barking out the intake so bad I can not hold my hand over it. I opened the valve cover and it look like the valve were working normally and not being held open as I first thought.
papastools Not Yet Wild Join Date: Aug 2018 Posts: 5

07-11-2019, 05:47 PM	#2
BearsFan315 Gone Wild Join Date: Dec 2017 Location: Portsmouth, VA Posts: 626	Re: rebuilt starter now running backwards per what i read on here, you can change rotation on the starter via swapping wires on A1 and A2 terminals do a search on here, been discussed a few times especially with the cw/ccw club cars !! main concern is wear on brushes if they have been running and worn in one direction

07-11-2019, 05:56 PM	#3
Fairtax4me Bonafide Nincompoop Join Date: Dec 2015 Location: Charlottesburg Va Posts: 8,987	Re: rebuilt starter now running backwards Need to move the green wire to A1 - F1. Negative to A2. Wire diagrams here:

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Forum
rebuilt starter now running backwards	Gas EZGO
I just rebuilt 84 2pg and not running HELP!	Gas EZGO
Engine running backwards	Gas Club Car
Carryall running backwards when stopping	Gas Club Car
87 Club Car Gas f82-Is it Running Backwards?	Gas Club Car

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum