|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
03-22-2016, 03:28 PM | #1 |
Gone Wild
Join Date: Nov 2011
Posts: 174
|
Curtis 906 reset problem
Replaced the OBC on a friend's cart. Prior to the OBC replacement the Curtis meter was working properly. After the OBC reset the gauge showed 2 bars. I read the spec sheet about the gauge automatically resetting when the proper reset voltage is applied. It would not reset when on the charger.
I put a power supply on the meter, ran it up to about 60 volts and let in go for about 6 minutes or so. The gauge reset properly. Put it back in the dash and it worked OK for a couple of days. Now it is back to the 2 bar charge indication. I'm trying to figure out how replacing the OBC had any effect on the Curtis gauge. Anyone experience the same issue? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Curtis Handheld 1313 4401 problem | Electric Club Car | |||
Curtis 1268 problem | Lifted Golf Carts | |||
club car/curtis speed controller problem / ? | Electric Club Car | |||
OBC reset problem | Electric Club Car | |||
Reset On Board Computer, Charging Problem | Extreme DC! |