06 series cart clicks but won’t move.

[Titleist1]

So recently my cart was acting up it would run fine and then just quit. It would sit for a while and then it would run again fine. I was going through cleaning all of the connections and found a loose connection on a motor post. After cleaning and tightening all connections the cart ran fine for a few weeks. Well the other day while playing golf it died and before even coming to a complete stop it took a off again. This happened a few times on the way home but I got home tightened all connections seemed like the motor post was a little loose again and went for a ride it ran fine. The next time I took it out I stopped and when trying to leave it wouldn’t go. The solenoid will click but it won’t move. I swapped motors thinking maybe the motor was the issue still no movement. Any ideas? Thanks

[mgray70]

Sounds like it could be the common 4 pin Molex connector that is located in the wire that runs from the throttle to the controller. It will either be located near the controller inside the controller cover, or I have seen them under the cart. Unplug and check for corrosion.

Sent from my SM-G930R4 using Tapatalk