11-16-2012, 11:52 AM | #1 |
Gone Wild
Join Date: Jul 2012
Location: Stuart, Fla
Posts: 205
|
Clutch question
I picked up an MPT 1200 as a parts doner car the other day. Mainly for body panels for my ST480. But the rearend was in it and it looks really good inside as far as bearings and the gears look. and my lift will fit the axle tubes. My problem is I need a part number for the driven clutch that goes on the rearend. The input shaft is tapered and not splined. If it was splinned that would be too easy as I have those clutches laying around. Any way if you have the part number of OEM or aftermarket I would greatly appreaciate it. Thanks.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-18-2012, 11:42 AM | #2 |
Gone Wild
Join Date: Jul 2012
Location: Stuart, Fla
Posts: 205
|
Re: Clutch question
Nobody has any ideas as far as the part number? As anyone seen a tapered shaft on the reared?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Clutch question | Gas EZGO | |||
Clutch Question | Gas EZGO | |||
Clutch Question | Big Block Talk! | |||
clutch question | Gas Club Car | |||
92 CC DS Clutch question? | Gas Club Car |