|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
04-07-2014, 05:02 PM | #11 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: Yamaha G1, has only one speed, all-out!!!
You can find the owner's manual in the stickys above. There is a procedure for setting the governor and the throttle.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-09-2014, 10:13 PM | #12 |
Not Yet Wild
Join Date: Apr 2014
Location: Southern Idaho
Posts: 16
|
Re: Yamaha G1, has only one speed, all-out!!!
Okay, been working on it. Wont idle down low. I think it could be a crank seal. I will search, but is there a thread for this procedure?
|
06-11-2014, 07:24 PM | #13 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,445
|
Re: Yamaha G1, has only one speed, all-out!!!
It is posted on here for sure but I don't know where. Lot of people hose up the throttle on those thinking it makes them faster.
|
06-12-2014, 06:26 AM | #14 |
Not Yet Wild
Join Date: May 2014
Location: Killdeer,ND
Posts: 4
|
Re: Yamaha G1, has only one speed, all-out!!!
Hey KKRRSS, have you figured your issue out yet? I think I have the same problem. I can unhook the throttle cable from gas pedal with no change. Dont make any sense to me. Does it have something to do with the switch under the pedal or is it linkage issues? Really aggrevating not to be able to idle around without kicking in and out constantly.
|
06-12-2014, 10:31 PM | #15 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,445
|
Re: Yamaha G1, has only one speed, all-out!!!
G1 tend to have common issues. One is the carb gets oily and it slips in the rubber boot, it twists sideways. This causes the throttle to be out of adjustment. Cure is pull carb and clean it and the inside of the rubber boots with carb cleaner (brake clean/etc) and put it back together with the carb straight up in the right spot. Next make sure the pedal cable is working and adjusted right. Pull up the floor and check the end of it. It should have the carb shut when pedal is up, it should trip the switch and turn over and start and idle BEFORE the carb opens at all. It should idle like a lawnmower or anything else, adjust the idle speed and mix so it does. Idle should be kind of slow though and like most 2 cycles it should miss at idle because its a little rich. If you have an issue of the switch not starting it, it should be adjusted to switch after little movement in the pedal and should turn it off when you let off. Should idle running if you hold the pedal down just a little say 1" down at top of pedal and less of its travel. Adjust the cable at the pedal to make it like that. Should be able to do this and still open the carb fully when you floor it. How the governor is adjusted or disabled will control max speed.
|
07-08-2014, 07:21 PM | #16 |
Not Yet Wild
Join Date: Apr 2014
Location: Southern Idaho
Posts: 16
|
Re: Yamaha G1, has only one speed, all-out!!!
Mine was a completely ruined pto side cranshaft seal. Just removed gas tank, clutch, and oil injector housings to access the seal. Idles low. Revs smooth.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Yamaha g16 speed problems. | Gas Yamaha | |||
Yamaha Gas Top Speed? | Gas Yamaha | |||
How do I speed up my yamaha g16 gas | Gas Yamaha | |||
Yamaha speed spring | Gas Yamaha | |||
yamaha speed spring | Lifted Golf Carts |