|
Electric golf carts Harley Davidson, Melex, Pargo, Taylor-Dunn and other Misc. Carts. |
|
Thread Tools | Display Modes |
01-04-2008, 09:14 PM | #1 |
Not Yet Wild
Join Date: Jan 2008
Posts: 3
|
EZ-GO 1984 Wiring problems
I am trying to help a friend who installed a new accelerator switch, and like all of us, he did not make a wiring diagram. To add insult to ijury, he removed and reinstalled other wires. (His problem was only a dead/dying battery) I found several schematics but they do not show the connection between the #4 terminal on the accelerator switch/resistor board to the A1 motor connection. I DO find wiring diagrams (not the same as a schematic) that do, but they are incomplete, such as not showing the +36 volt connection to the solenoid. Another wiring diagram shows what I believe is a solenoid being operated from +6v, which is no problem. However, I would like to rewire it as much like it was as I can. Even so, when I draw a POWER diagram, these wiring diagrams seem to make no sense. Help!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
1984 ezgo two stroke | Gas EZGO | |||
1984 Yamaha G1 - Project Cart | Members Rides | |||
Information on a 1984 Club Car | Electric Club Car | |||
wiring problems | Electric EZGO | |||
1984 EZGO help a newbie? | Gas EZGO |