12-04-2012, 06:26 PM | #11 |
Gone Wild
Join Date: Dec 2007
Location: SE Indiana
Posts: 390
|
Re: Clutch woes
The movable face side. I have it machined until there is a 3/8 wide flat spot, Don't do more or you may machine it in half.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-04-2012, 07:29 PM | #12 |
Getting Wild
Join Date: Oct 2012
Location: north central, indiana
Posts: 105
|
Re: Clutch woes
Do you have a diagram or picture that helps describe what you are saying. Thanks
|
12-05-2012, 06:36 AM | #13 |
Gone Wild
Join Date: Dec 2007
Location: SE Indiana
Posts: 390
|
Re: Clutch woes
No, On the side of the clutch tat moves in and out have machined the inner most edge to 3/8. That way the clutches will go closer together.
|
12-05-2012, 05:20 PM | #14 |
Getting Wild
Join Date: Oct 2012
Location: north central, indiana
Posts: 105
|
Re: Clutch woes
oh, i get it. so the halfs are closer together. then scoot the engine back some because the belt would be tighter because its higher in the pulley. do i just machine the moveable shive and leave the other alone....
|
12-06-2012, 06:25 AM | #15 |
Gone Wild
Join Date: Dec 2007
Location: SE Indiana
Posts: 390
|
Re: Clutch woes
Yes
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Electrical Woes... | Electric Club Car | |||
3PG woes | Gas EZGO | |||
engine woes | Gas EZGO | |||
G1 Torque Kit Woes | Gas Yamaha | |||
New camera woes | Test Post |