|
|
|||||||
| Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
03-12-2013, 10:21 AM
|
#1 |
|
Gone Wild
 Join Date: Oct 2011
Location: Cowtown Texas
Posts: 180
|
TXT Clone Swap Questions
Searched and looked the forum over, and couldn't find definitive answer. Can you use the CPP engine cradle for a HF Clone, or is it just strictly for big block? I don't need speed, I need torque low end for hills and such.
Mine is now lifted 6 inches, and would the CPP cradle keep it more level? I saw to get the adapter for the sleeve taper, and possible cut the crank down some. How much to cut the shaft down to? Any other pitfalls/tips/tricks to know about? I wish there was a EZGO Sticky compiled of the process. Thanks In Advance! |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-12-2013, 11:05 AM
|
#2 |
|
Younger Than Dirt
Join Date: Aug 2007
Location: North Myrtle Beach SC
Posts: 2,047
|
Re: TXT Clone Swap Questions
The bolt pattern is the same,I switched mine from a clone to V-twin,didn't have to re drill
 hookm |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Txt clone swap | Clone Engine Swaps | |||
| ez go clone swap | Clone Engine Swaps | |||
| Clone swap help | Clone Engine Swaps | |||
| g2 clone swap thanks to all of you here | Clone Engine Swaps | |||
| Another Clone Swap | Clone Engine Swaps | |||
Linear Mode
