|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
07-08-2019, 07:54 PM
|
#51 |
|
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,226
|
Re: Connecting Problem
First that wiring diagram you posted is for 6 volt batteries.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-08-2019, 08:02 PM
|
#52 |
|
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: Connecting Problem
This is how I’ve done all of my DS carts. I make my own 4ga cables and use about 20-24” less cable than the stock setup by re-arranging them this way.
And before anyone gives me flack for it... The small wires are for a Single 14w LED headlight. It only draws about 0.75 amps when it’s on (checked it with my ammeter to be sure). I have those on almost all of my carts. They only tend to get used about 2-3 hours in a night and they’re only used about 4 months out of the year. I have had no issue with having such a low draw connected to only two batteries. It’s minuscule compared to a full Head and tail light set. |
|
|
|
|
07-08-2019, 08:24 PM
|
#53 |
|
Getting Wild
Join Date: Aug 2018
Posts: 85
|
Re: Connecting Problem
I appreciate the feedback. That's how I learn on here.
I found a CC DS 48V wiring diagram and I rearranged my entire pack to match the diagram. I hope this looks better. (Again, the black charge cable is still off till I'm done working on it). I've got 49.2 volts on the pack, but that's because I haven't been able to charge my batteries yet. I've also got 49 volts from the +solenoid and -controller. If I read right, that should be the proper voltage reading. So I'm assuming I have the pack wired properly. I'm trying lol   Sent from my SM-N910V using Tapatalk |
|
|
|
|
07-08-2019, 08:53 PM
|
#54 |
|
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,226
|
Re: Connecting Problem
Did you intentionally not connect the + and - charging connections?
|
|
|
|
|
07-08-2019, 09:05 PM
|
#55 |
|
Getting Wild
Join Date: Aug 2018
Posts: 85
|
Re: Connecting Problem
Got a new DC receptacle ordered. Be here tomorrow hopefully. That's why my negative is still off
Sent from my SM-N910V using Tapatalk |
|
|
|
|
07-12-2019, 07:04 PM
|
#56 |
|
Getting Wild
Join Date: Aug 2018
Posts: 85
|
Re: Connecting Problem
Installed the new DC receptacle today. No change. Charger still faults out and turns off. Lester is going to send me a new charger. Process of elimination. I appreciate them offering a new replacement. Good customer service. Hopefully that solves my problem.
Sent from my SM-N910V using Tapatalk |
|
|
|
|
07-12-2019, 09:10 PM
|
#57 | |
|
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,226
|
Re: Connecting Problem
Quote:
|
|
|
|
|
|
07-13-2019, 08:12 AM
|
#58 |
|
Getting Wild
Join Date: Aug 2018
Posts: 85
|
Re: Connecting Problem
Not a current picture. Just installed the new DC wiring harness yesterday. + to positive on number 1 battery, - to pack negative on number 6 battery. Still won't charge
Sent from my SM-N910V using Tapatalk |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Connecting rods | Gas EZGO | |||
| Battery connecting | Electric EZGO | |||
| g1 connecting rod pin | Gas Yamaha | |||
| G1 connecting rod removal | Gas Yamaha | |||
| G16 connecting ROD | Golf Carts and Parts | |||
Linear Mode
