Full view of 1977 ez-go 36v wiring hook up

[jpchief]

Need a Wiring diagram for a 1977 ez go 36v shows selinoid and f/r hook up. large if possible, all most blind, thanks for any help anyone can do. also how you can check to see if moter is good? thanks JP

[rib33024]

Welcome to BGW

this big


http://www.buggiesgonewild.com/elect...g-manuals.html


SEPEX motor check[/h2]

• Turn off, remove key, jack up car so rear wheels are off ground.
• Remove all cabling from motor. Mark where each cable was connected to motor.
• With a jumper connect A1 to F1
• With a jumper connect A2 to F2
• Supply power to the A terminals.(12 volts should be fine)
• Use at your own risk. A small spark is expected each time you make/break the connection. Dont forget to jack the cart up and get the rear wheels off the ground. Make sure the brake is off.

Series motor check

• Turn off, remove key, jack up car so rear wheels are off ground.
• Remove all cabling from motor. Mark where each cable was connected to motor.
• With a jumper connect S1 to A2.
• Supply power to the A1 and S2 terminals.(12 volts should be fine)
• Use at your own risk. A small spark is expected each time you make/break the connection. Dont forget to jack the cart up and get the rear wheels off the ground. Make sure the brake is off.

Solenoid Check

[list][*]Disconnect both large and small wires from solenoid[*]Supply pack voltage to the small terminals. Should click[*]With a volt/ohm meter check the large terminals for continuity. Just because it clicks doesn't mean its good