03-03-2018, 12:38 AM | #1 |
Not Yet Wild
Join Date: May 2015
Posts: 13
|
RXVCharger
I have a new delta Q 48 volt charger for an RXV that requires a signal from the RXV's on-board computer to activate the charger. MyCart is a ACG california roadster that doesn't require that 3rd wire and only uses's the hot and ground to charge. My question is how do I send a signal to the charger thru the 3rd wire to make the charger work?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-03-2018, 02:48 AM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: RXVCharger
10k ohm resistor from green wire to black wire.
|
03-03-2018, 08:59 AM | #3 |
Not Yet Wild
Join Date: May 2015
Posts: 13
|
Re: RXVCharger
So Your saying White to the positive, black to the negative and attach the green wire to the black wire with a 10k 0hm resistor? Then my charger will kick on?
|
03-03-2018, 12:40 PM | #4 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: RXVCharger
Yep, and the charger should be "off-board", where it will get disconnected from pack after every charge.
|
03-03-2018, 01:27 PM | #5 |
Not Yet Wild
Join Date: May 2015
Posts: 13
|
Re: RXVCharger
Thanks
|
03-03-2018, 01:42 PM | #6 |
Not Yet Wild
Join Date: May 2015
Posts: 13
|
Re: RXVCharger
Thanks
|