|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
09-08-2018, 10:32 AM
|
#21 |
|
Not Yet Wild
Join Date: Sep 2018
Location: NC
Posts: 26
|
Re: Early 80s DS new electronics 48v conversion
I like newer better and also the 25-30mph. I think the controller is already missing off this. If you see anything sense let me know. I can take more pictures if needed.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-08-2018, 10:48 AM
|
#22 |
|
Gone Wild
 Join Date: Jun 2017
Location: Savannah, GA
Posts: 6,539
|
Re: Early 80s DS new electronics 48v conversion
Look under the cover and see if the controller is there. Is the wiring harness complete and in good shape?
Club Car DS driver’s club #59 |
|
|
|
|
09-08-2018, 10:52 AM
|
#23 |
|
Not Yet Wild
Join Date: Sep 2018
Location: NC
Posts: 26
|
Re: Early 80s DS new electronics 48v conversion
I’ll check when I get back home. Pretty sure controller is gone already.
|
|
|
|
|
09-08-2018, 11:00 AM
|
#24 |
|
Gone Wild
Join Date: Jun 2017
Location: Savannah, GA
Posts: 6,539
|
Re: Early 80s DS new electronics 48v conversion
Hopefully it’s not a flood cart.
Club Car DS driver’s club #59 |
|
|
|
|
09-08-2018, 11:20 AM
|
#25 |
|
Not Yet Wild
Join Date: Sep 2018
Location: NC
Posts: 26
|
Re: Early 80s DS new electronics 48v conversion
Hadn’t thought about that.
|
|
|
|
|
09-08-2018, 12:45 PM
|
#26 |
|
Gone Wild
Join Date: Jun 2017
Location: Savannah, GA
Posts: 6,539
|
Re: Early 80s DS new electronics 48v conversion
It should be pretty obvious. Check the harness connectors and look for corrosion.
Around here if a motor and controller are both either missing or bad, it almost guarantees it was flooded with salt water. But up there may be different[emoji106][emoji2532] Club Car DS driver’s club #59 |
|
|
|
|
09-08-2018, 03:13 PM
|
#27 |
|
Not Yet Wild
Join Date: Sep 2018
Location: NC
Posts: 26
|
Re: Early 80s DS new electronics 48v conversion
Doesn’t look flooded but these wire were cut.
Last edited by ChunkyChewbacca; 09-08-2018 at 03:14 PM.. Reason: Add photo |
|
|
|
|
09-08-2018, 04:17 PM
|
#28 |
|
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: Early 80s DS new electronics 48v conversion
Looks like the controller is gone and they cut the controller 16 pin harness plug out.
New IQ harnesses are in the $150 range. A new harness will rewire pretty much the whole thing and then you just pick out a nice high amp controller, solenoid, and a motor upgrade. There are plenty of controller options that would not require a new harness plug. You would just need a wire diagram to identify each wire so it can be correctly connected to a new controller. Check the fluid in that rear axle for water and for sparkles/metal flakes, and spin the input shaft by hand to feel for play or roughness in the bearings. |
|
|
|
|
09-08-2018, 04:31 PM
|
#29 | |
|
Gone Wild
Join Date: Jun 2017
Location: Savannah, GA
Posts: 6,539
|
Re: Early 80s DS new electronics 48v conversion
Quote:
What a terrible way to remove the controller plug. You will need a new harness. Club Car DS driver’s club #59 |
|
|
|
|
|
09-08-2018, 05:16 PM
|
#30 |
|
Not Yet Wild
Join Date: Sep 2018
Location: NC
Posts: 26
|
Re: Early 80s DS new electronics 48v conversion
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Mud in the electronics | Electric EZGO | |||
| Fuel & Electronics? | Gas Yamaha | |||
| Wtb txt pre mci electronics | Golf Carts and Parts | |||
| 12 v timer for electronics | Gas EZGO | |||
Linear Mode
