|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
02-27-2019, 11:23 PM | #1 |
Not Yet Wild
Join Date: Feb 2019
Posts: 5
|
Handheld Programmer For Curtis Controller
I just purchased a 500A Curtis controller (SEP EX 76-126 and I would like to know if there is a handheld programmer or a “on the fly” switch setup with different presets available?
Thanks! Jesse 09’ Yamaha Drive |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-28-2019, 12:15 AM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Handheld Programmer For Curtis Controller
Yes, there is a programmer, but it isn't cheap. And the controller is capable of a mode switch, the question is "is the software installed set up for 2 modes?", Some are, some aren't.
|
02-28-2019, 12:58 AM | #3 |
Not Yet Wild
Join Date: Feb 2019
Posts: 5
|
Re: Handheld Programmer For Curtis Controller
Yes, I have a dual mode switch for high speed or low torque
|
02-28-2019, 02:16 AM | #4 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Handheld Programmer For Curtis Controller
The handheld programmer is not setup for use by the average end user, it doesn't have a UI that the average end-user would enjoy. It's made as a diagnostic/programming tool, not intended for permanent installation for OTF programming.
|
02-28-2019, 07:41 PM | #5 |
Not Yet Wild
Join Date: Feb 2019
Posts: 5
|
Re: Handheld Programmer For Curtis Controller
Sounds like the handheld might be my only option with that Curtis controller then..?
How do I adjust my peramitors within mode “1” and “2” switch connected to controller? |
02-28-2019, 10:45 PM | #6 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Handheld Programmer For Curtis Controller
I wish that were an easy answer. Everyone who sells those controllers puts different software in them, from the OEMs, to the aftermarket suppliers, to the rebuilders. The menus provided will look different with each. And then there is the issue of "access level", a "level 1" handheld programmer will show minimal stuff, while a "level 4" handheld shows much more. What each level handheld shows will vary by how the supplier had their unique software written. This is what I was alluding to when i said it wasn't friendly to the end user (golf cart owner).
|
Tags |
curtis, programmer, yamaha drive |
|
|
Similar Threads | ||||
Thread | Forum | |||
Curtis Handheld Programmer | Electric golf carts | |||
Curtis Handheld Programmer Adapter Cables | Golf Carts and Parts | |||
Curtis Handheld Programmer Adapter Cables | Golf Carts and Parts | |||
Curtis 1313-3301 handheld programmer | Golf Carts and Parts | |||
Curtis 1307 Handheld Programmer | Golf Carts and Parts |