|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
05-16-2010, 03:48 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2010
Posts: 22
|
I.D. my ezgo and help with parts
I found the manufacturer tag: manufacturer code : K201, serial # 1419172.
Based on that info what are some basic add-ons/mods I can do to give it some extra cajones. The first parts I bought were retractable seat belts for my kids from everythingcarts and while I was on phone she suggested some $18 converter to give me some extra power but didn't buy because i didn't know if it would be compatible with my cart. |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
05-16-2010, 04:08 PM
|
#2 |
|
Just one day at a time
 Join Date: Sep 2009
Location: South TX
Posts: 8,650
|
Re: I.D. my ezgo and help with parts
Your cart was built in Nov 01
Where is your forward and reverse switch? |
|
|
|
|
05-16-2010, 09:34 PM
|
#3 |
|
Not Yet Wild
Join Date: May 2010
Posts: 22
|
Re: I.D. my ezgo and help with parts
forward/reverse is below the seat. Is my cart a PDS or SDS?
|
|
|
|
|
05-16-2010, 09:41 PM
|
#4 |
|
Getting Wild
Join Date: Apr 2010
Location: PR
Posts: 119
|
Re: I.D. my ezgo and help with parts
Either series or DCS.
Does the FNR switch has a rod inside connecting to a board? |
|
|
|
|
05-16-2010, 10:21 PM
|
#5 |
|
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: I.D. my ezgo and help with parts
This will help
Can you verify the year and tell us which one of the three drive systems you have? The last 2 numbers of the manufactures code is the year, located inside the passenger side glove box, the 2004 and newer ezgos dont have a serial number plate in the box, they have a serial number sticker under the rear access panel behind the seat, and then on the driverside frame rail below the floor board. DCS will have a F&R lever behind the driver's knee and a run/tow switch on the enviromental cover on the controller. The backside of the f&R looks round like a hockey puck. PDS carts will have a Tow/Run switch with toggle switch for F&R on the dash SERIES carts will have a shift lever like the dcs cart down by your legs, but it will NOT have a tow/run switch. Also the actual F&R switch is in the corner by the controller and there is linkage from it to the lever in the center..... |
|
|
|
|
05-16-2010, 10:30 PM
|
#6 |
|
Not Yet Wild
Join Date: May 2010
Posts: 22
|
Re: I.D. my ezgo and help with parts
The code and serial i listed in my original post. The F/R toggle has a rod linking to a box on the passenger side of the vehicle so it sounds like its a series. Is that good or bad as far as upgrading goes?
|
|
|
|
|
05-17-2010, 10:41 PM
|
#7 |
|
Not Yet Wild
Join Date: May 2010
Posts: 22
|
Re: I.D. my ezgo and help with parts
Well after reading up I think I am going to upgrade to 4 ga.wires all around then look at a new controller,I am thinking the AXE 4845 if it still under-power.
|
|
|
|
|
05-17-2010, 10:56 PM
|
#8 |
|
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: I.D. my ezgo and help with parts
4 ga is a good upgrade all the cables batteries to motor to controller to F/R
What is your cart 36 V--or - 48 V??? |
|
|
|
|
05-18-2010, 09:30 AM
|
#9 |
|
Not Yet Wild
Join Date: May 2010
Posts: 22
|
Re: I.D. my ezgo and help with parts
36V cart, not interested in going to 48v at this time really. I just want a little extra power to get up driveways etc.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Ezgo Parts | Golf Carts and Parts | |||
| 92 ezgo parts? | Design Center | |||
| Used EZGO parts | Golf Carts and Parts | |||
Linear Mode
