|
|
|||||||
| Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
03-31-2015, 07:26 AM
|
#1 |
|
Not Yet Wild
Join Date: Jul 2014
Posts: 22
|
Micro (limit?) switch testing
I just picked up a 1993 4 cycle EZGo with the 295 Pre-MCI Robin engine. I replaced the starter/generator, solenoid, and battery, and I re-did some of the old (corroded) wiring. I think the micro switch is either wired incorrectly or is bad because when I turn the key to on, the starter/generator runs without depressing the gas pedal. Is there a way to test this switch with a voltmeter or should I just replace that too?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-31-2015, 07:52 AM
|
#2 |
|
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,572
|
Re: Micro (limit?) switch testing
Disconnect the wires, and set your meter on ohms. It should read open, and closed circuit depending on the position. You should also hear it clicking while operating the switch.
It's nothing more than a spring loaded lever with a set of contacts. |
|
|
|
|
03-31-2015, 12:06 PM
|
#3 |
|
Not Yet Wild
Join Date: Jul 2014
Posts: 22
|
Re: Micro (limit?) switch testing
Ok, I'll try that out tonight. Thanks for your help!
|
|
|
|
|
05-22-2015, 11:07 AM
|
#4 |
|
Not Yet Wild
Join Date: Jul 2014
Posts: 22
|
Re: Micro (limit?) switch testing
Long delayed reply. The microswitch was bad so I replaced it. Thanks for the help!
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 98 Club Car 36v resistor no micro(limit) switch! | Electric Club Car | |||
| speed limit switch | Electric Club Car | |||
| What is G14E Limit switch? | Electric Yamaha | |||
| Forward Reverse switch limit switch | Electric Club Car | |||
Linear Mode
