Epic by Icon speed adjust

[Btenney]

Zip tied to harness soon as it comes out of the controller box area



I’m located in largo Florida

[derelicte]

That could be for the motor temp sensor.

[KRAZYMATT]

Originally Posted by derelicte

That could be for the motor temp sensor.

No inputs for motor temp sensors on this controller.

[Syclone]

I know it can be done (2022 E40L)- my seller was able to raise the max speed/RPM of the motor, but did not change the max amp draw - so it can do 31-32 but only with little wind, and a slight decline helps. Once the cables become available I would like to get one and the software to take a crack at it myself.

[__JAG__]

Originally Posted by Syclone

I know it can be done (2022 E40L)- my seller was able to raise the max speed/RPM of the motor, but did not change the max amp draw - so it can do 31-32 but only with little wind, and a slight decline helps. Once the cables become available I would like to get one and the software to take a crack at it myself.

Yeah I saw the same. Raising the max speed will allow the motor controller to spin the motor up to a higher RPM, but the factory current limits are set to low to achieve these higher RPM's.

[KRAZYMATT]

Originally Posted by __JAG__

Yeah I saw the same. Raising the max speed will allow the motor controller to spin the motor up to a higher RPM, but the factory current limits are set to low to achieve these higher RPM's.

The epics use different controller and software from the icons.

[ezmuzic]

I can't wait for a cable and software to be available.

[carld]

Jag. I have 2022 icon 450 amp controlle. I have cable and software. I have fixed all I want to fix. But can’t seem to get mph past 27. I try to change kph to 56. But it automatically locks it back to 48.6

[__JAG__]

Originally Posted by carld

Jag. I have 2022 icon 450 amp controlle. I have cable and software. I have fixed all I want to fix. But can’t seem to get mph past 27. I try to change kph to 56. But it automatically locks it back to 48.6

I would check the value of 06.01.01, this I bet is at 7200, which is the max it will allow. That is why your being limited to 48.6 most likely. But what I don't know and cannot figure out is why some carts are limits to 48, but I mine will go to 60kph. My guess is it has something to do with the gearing, but not sure why they would supply carts with different gearing.

What is your:
Gear Ratio - 03.03.03
Tire Diameter - 03.03.04

Do you have lifted or non-lifted model?

[KRAZYMATT]

Carl also check on the section 01 and post what it says for configuration id and fw id