GTW Mach3 Rear Flip Seat

[Z7What]

I ordered a GTW Mach3 Rear Flip Seat for our 2011 Precedent when we first got it. We finally receive it yesterday and I got it installed.

Here are my thoughts

THE BAD:

It took over a month to receive when it was stated that it was in stock when I ordered it. Turns out, it was not in stock.

Although the instructions are pretty with colored pictures they don't give the detailed info needed to make sure you are installing it correctly.

No where on any site I looked at does it state that the storage/cooler box is NOT included. It was the single reason why I purchased this kit and now I have to spend more money to get the storage/cooler box.

The hinge on the storage/cooler box was broken right out the box. Im hoping that its not going to be a issue getting it replaced. The biggest issue is that im going to have to remove most of the back seat to get to the screws out to remove the lid in order to replace.

The end of the angle iron on the drivers side where the arm rest attached was slightly bend but was easily bent straight.

One of the nut inserts on the bottom of the back seat didn't have threads in it for the screw to secure it to the bracket. I had to tap it so the bolt would screw in.

THE GOOD:

Over all its a nice kit and the powder coating on the kit seams to be done nicely. All the hardware is metric, just like the cart. Most other aftermarket items uses standard sized hardware which requires you to pull more tools out.

Now I need to order new seat covers so the front and rear seats match!




Wayne

[Chamberlin_d]

Old thread I know, hopefully you are still around. Have the same problem with the lid being broken right out of the box. I opted to stop working on it until I get an answer about a replacement. Can you shed any light, part numbers, for replacing it?