|
03-06-2014, 05:31 PM
|
#1 |
|
Not Yet Wild
Join Date: Feb 2013
Posts: 8
|
01 295 camshaft
i have a 01 295 that i am rebuilding,i have built a couple of these for friends and never paid much attention to the cam until now i was cleaning this one and noticed all of the lobes were not smooth they had like ridges on them,is this normal or is this wear has anyone seen this before.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-06-2014, 06:53 PM
|
#2 |
|
Gone Wild
Join Date: Apr 2009
Location: indiana
Posts: 274
|
Re: 01 295 camshaft
time for a new cam!
and check the lifters, something got in the engine oil and ate it up! are the piston walls scored? whats the crank look like? sounds like a ground up rebuild to me! |
|
|
|
|
03-07-2014, 04:43 AM
|
#3 |
|
Not Yet Wild
Join Date: Feb 2013
Posts: 8
|
Re: 01 295 camshaft
the rockers looked the same way,the cyl.walls cleaned to stock specs.the timing gear on the crank slipped and caused the rods to hit the counterbalance shaft,had a golf cart shop in ga.tell me it was common for that gear to slip i have had others tell me it was overrevved,going to start with a fresh rebuild check govenor and go with that.thanks for the help and advice.
|
|
|
|
|
03-07-2014, 05:17 AM
|
#4 |
|
Gone Wild
Join Date: May 2009
Location: Eustis Fl.
Posts: 154
|
Re: 01 295 camshaft
If i was going to spen the money on the rebuild i would upgrade to a vanguard is well worth it .
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Vanguard Camshaft Modifications | Big Block Talk! | |||
| Changing camshaft | Big Block Talk! | |||
| Camshaft | Gas EZGO | |||
| Stock vs hot camshaft | Gas EZGO | |||
| Yamaha G9 camshaft bearings | Gas Yamaha | |||
Linear Mode
