A couple of switch questions - Run/Tow and Alltrax "Personality"

[JaxPilot]

First, I want to relocate the Run/Tow switch on my 99 DCS TXT, and place a covered toggle on the dash. Run will be cover closed and switch down to protect from inadvertent toggle, and Tow will be cover open and switch up. I have read older posts on the site that say it is a DPDT switch, but the original run/tow only has 4 terminals on it, while all the DPDT I have found have 6 terminals. What is the proper throw / pole setup for a replacement switch?

Also, I would like to place another toggle (probably semi-hidden) and use it to switch personalities on the Alltrax XCT. Basically I want a "kiddy" mode and a "daddy" mode, and the ability to switch between them with just the toggle. I will have to save up to do the full blown FNKS setup. I thought I read about this earlier, but my searches have not turned up the thread I was looking for. Is this possible, and if so how would I wire it and what type of switch would I need?

[Gregorio]

Pretty sure the Run/Tow is DPST on your cart. That means there are two separate circuits that are either open or closed.

The switch for Alltrax personalities is SPDT. This has 3 terminals. See the wiring diagrams in the install manual.

[net]

Call altrax . Ask for will
He tell you

Enviado desde mi SGH-I337M mediante Tapatalk