EZ-GO TXT motor assembly

LukeL · 08-21-2017, 02:09 PM

Hello everyone,

I recently purchased a used motor from a member on this site, and it was packaged very well, but it had obviously been thrown around by our wonderful mail...

The center moving part of the motor with the shaft slid out of it, and I can’t seem to slide it back in without it getting caught on the brushes down inside.

Can you tell me the proper way to put it back in without damaging the brushes? I assume the motor survived, but I will test it once I get it installed on the car if I can ever assemble it.

Thank you
Luke

Club Car DS Driver’s Club #59

08-21-2017, 05:47 PM

You Tube

08-21-2017, 02:09 PM	#1
LukeL Gone Wild Join Date: Jun 2017 Location: Savannah, GA Posts: 6,539	EZ-GO TXT motor assembly Hello everyone, I recently purchased a used motor from a member on this site, and it was packaged very well, but it had obviously been thrown around by our wonderful mail... The center moving part of the motor with the shaft slid out of it, and I can’t seem to slide it back in without it getting caught on the brushes down inside. Can you tell me the proper way to put it back in without damaging the brushes? I assume the motor survived, but I will test it once I get it installed on the car if I can ever assemble it. Thank you Luke Club Car DS Driver’s Club #59

Similar Threads
Thread	Forum
87 seized motor dis-assembly questions	Gas EZGO
Tie Rod Assembly Nut	Electric EZGO
tie rod assembly	Electric EZGO
ITS assembly.	Electric EZGO
How strong is the gas motor rear axle assembly?	Gas EZGO

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum