2005 EZGO Governor?

[juicefree43]

Originally Posted by Legendary Golf Carts

put the cart back into diagnostic. After it is in diagnostic, start driving, record the number and pattern of beeps, and then read the label on the cover until the beep code you got has a match. Tell us the beep code and the problem, make sure the cart is moving because some beep codes require the cart to be driving to diagnose.

When the cart was in Diagnostic mode yesterday, in slow speed it would be beep three times, then stop, then repeat. I would turn the key off then back to on (to remove the governor) so it would go into full speed and the beeping stopped. When i would bring the cart to a full stop and its back in slow speed it would start beeping again.

So to answer your question it was 3 beeps then it would stop.

[juicefree43]

Originally Posted by Legendary Golf Carts

put the cart back into diagnostic. After it is in diagnostic, start driving, record the number and pattern of beeps, and then read the label on the cover until the beep code you got has a match. Tell us the beep code and the problem, make sure the cart is moving because some beep codes require the cart to be driving to diagnose.

When the cart was in Diagnostic mode yesterday, in slow speed it would be beep three times, then stop, then repeat. I would turn the key off then back to on (to remove the governor) so it would go into full speed and the beeping stopped. When i would bring the cart to a full stop and its back in slow speed it would start beeping again.

So to answer your question it was 3 beeps then it would stop.

[Legendary Golf Carts]

you have fault code 3-3 "solenoid did not close, vehicle will not run, check all solenoid wiring and replace if required" sounds like the previous owner did not wire the solenoid correctly.