|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
08-03-2013, 11:40 PM | #1 |
Not Yet Wild
Join Date: Jul 2013
Posts: 5
|
G9 94 wiring/starter problems
Recently my G9 worked perfect until the starter went out. Had the starter rebuilt and put back on, but no one marked which wires went where. I found the wiring diagrams and hooked everything back up accordingly.
Except it still doesn't run. The ignition needed changed also, it was a redneck ignition that used a screwdriver as a key. So i ordered one from the golf cart king and plugged it in. The golf cart doesn't start, click, make any noise when the key is turned, nor the peddle depressed. Four mechanics have looked at it and cannot tell me what is wrong with it. If someone can tell me how to test the coil, and misc. switches, I would greatly appreciate it. Not spending any more money on people telling me they cannot figure it out. Thank you for any and all replies, and please it is usually the simplest answer and I don't mind checking and rechecking wiring!! I will be happy when my beast is running again!! Kris |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-04-2013, 06:54 AM | #2 |
Gone Wild
Join Date: Jul 2011
Location: Central Arkansas
Posts: 166
|
Re: G9 94 wiring/starter problems
|
08-04-2013, 08:00 AM | #3 |
Gone Wild
Join Date: Sep 2010
Location: Erie, Pennsylvania
Posts: 989
|
Re: G9 94 wiring/starter problems
You "fixed" too many things at the same time. After you read and make copies of the items suggested by sontag1 and rechecked the starter circuit wiring, I would start by sorting out the starter/gen circuit. First, (with all switches off), momentarily jumper the solenoid's large terminals together. Cart should crank! Then check the solenoid as follows: You should be able to crank (turn over) the engine by energizing the solenoid by inserting a jumper wire from bat. + to the solenoid terminal where the small R/W wire attaches to it (remove the existing R/W wire first). Solenoid should pick-up and cart should crank as soon as you energize that solenoid terminal. Once you have that sorted out and working, you can go on to check the wiring and switches in the starting circuit. Gotta take things one at a time. Report findings. Good luck - RAY
P.S. - Oh, make sure your battery connections are clean and tight and it is fully charged BEFORE doing any troubleshooting. Last edited by bigstik40; 08-04-2013 at 08:03 AM.. Reason: corrections |
08-08-2013, 10:21 PM | #4 |
Not Yet Wild
Join Date: Jul 2013
Posts: 5
|
Re: G9 94 wiring/starter problems
Thank you very much, I will try all of these and let you know! Fingers crossed!!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Starter Problems | Gas Harley Davidson | |||
Starter problems | Gas Club Car | |||
Starter Problems | Gas EZGO | |||
Starter problems | Gas Club Car | |||
Starter problems | Gas Club Car |