|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
01-10-2016, 07:44 AM | #1 |
Not Yet Wild
Join Date: Apr 2013
Posts: 8
|
06 No power to anything
I am working on a 06 and at first had no power except at the batts. Jumped the reed switch now have power at terminals #4 & 5 and solenoid clicks but no go. What to check next? Cart is all stock
Poorloser |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-10-2016, 08:54 AM | #2 |
Gone Wild
Join Date: Jan 2014
Location: South Georgia
Posts: 1,120
|
Re: 06 No power to anything
You need to supply more info about the exact cart model you are working on.
|
01-10-2016, 11:14 AM | #3 |
Not Yet Wild
Join Date: Apr 2013
Posts: 8
|
Re: 06 No power to anything
OK I don't own an ezgo so What do you need to know? It's an 06 what else
|
01-10-2016, 11:22 AM | #4 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 06 No power to anything
What type drive system?
|
01-10-2016, 02:24 PM | #5 |
Not Yet Wild
Join Date: Apr 2013
Posts: 8
|
Re: 06 No power to anything
The cart is Sepex DCS
Thank You JohnnieB |
01-10-2016, 02:36 PM | #6 |
Stay thirsty my friends!
Join Date: Jan 2007
Location: Suburban Chicago
Posts: 24,283
|
Re: 06 No power to anything
An '06 Sepex should be a PDS, not a DCS. Is your F/R switch on the dash next to the keyswitch? If so, you have a PDS.
|
01-10-2016, 02:56 PM | #7 |
Not Yet Wild
Join Date: Apr 2013
Posts: 8
|
Re: 06 No power to anything
No the F/R lever is down on the front of the batt. compartment ant it turns a disk with 2 micro switches one on each side. I'm sorry I just ran over to the cart and it is a 1996 Model
|
01-10-2016, 02:59 PM | #8 |
Stay thirsty my friends!
Join Date: Jan 2007
Location: Suburban Chicago
Posts: 24,283
|
Re: 06 No power to anything
That info makes sense now.
|
01-10-2016, 03:22 PM | #9 |
Not Yet Wild
Join Date: Apr 2013
Posts: 8
|
Re: 06 No power to anything
Sorry about that. Now I have Power to #4 & 5 and the solenoid clicks when the F/R lever is rotated to which ever direction. What can I check next? I only have power to pins 4&5 when the F/R lever is rotated not when in neutral.
|
01-10-2016, 06:38 PM | #10 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 06 No power to anything
Quote:
Also, you may be counting the pins from the wrong side. Pin-1 has a white wire on it. Attached is a schematic for a DCS controller. Does the solenoid click without the pedal being pushed when the F/R lever is in either F or R? (If so, you have more than one problem) ------------ Measure the voltage between the controller's B- and M- terminals when the solenoid clicks You should read pack voltage with the pedal up and close to zero with it on floor. |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
G1 not starting...no power power coming from magneto? | Gas Yamaha | |||
Full power in reverse, part power in forward | Electric EZGO | |||
2005 Precedent starts of powered, then loses power, reverse always power | Electric Club Car | |||
Power Wise Charger worked after board replaced now back to no power | Electric EZGO | |||
have power on ezgo buggy no power light | Electric EZGO |