Club car selonoide clicks but no go

[samsggrams]

2000 club car with already npx controller batteries at 50.5 selenoide clicks light on controller blinks 7 times green but it doesn’t move,, what can I test?????

[WalterM6]

1 Red = Throttle Position Sensor Over Range. Check for open wires.
2 Red = Under Temperature. Controller below -25C
3 Red = HPD. Throttle hasn’t gone to zero during this power on cycle.
4 Red = Over Temperature. Controller over 95C
5 Red = Not used
6 Red = Battery Under Voltage detected. Battery V < under voltage slider
7 Red = Battery Over Voltage detected. Battery V > over voltage slider

Check this. Error code display: # of RED blinks indicates any error conditions that might exist:

[samsggrams]

There are no red blinks , just 7 green,,

[NoleFan4Ever]

Originally Posted by samsggrams

2000 club car with already npx controller batteries at 50.5 selenoide clicks light on controller blinks 7 times green but it doesn’t move,, what can I test?????

All that means is you have a 5k-0 ohms 3 wire throttle

That occurs at start (power) up. What does it do "after" that? It should become solid green (or red for programming and yellow for max output but not at current limit)

[samsggrams]

Solid green

[NoleFan4Ever]

Originally Posted by samsggrams

Solid green

That is exactly as it should be.... Do you have an MCOR or V-glide (multi-step potentiometer)?

You need to see if you are getting the throttle signal to the controller.

[samsggrams]

How can I check if it is sending power to the motor???

[samsggrams]

Put new m core on it and does the same thing?

[NoleFan4Ever]

Originally Posted by samsggrams

Put new m core on it and does the same thing?

You have already replaced the MCOR?

[NoleFan4Ever]

Originally Posted by samsggrams

Put new m core on it and does the same thing?

Take the yellow wire off pin 3 on your controller and with the cart jacked up, in forward, and key on, check the voltage from pedal up to pedal down and it should go from 0 to 5 volts gradually changing.