Alltrax sr 48500

[rammit]

Can anyone shed some light on how to change the setting on this controller. I read something about having to disconnect it before adjusting the settings. In the setting is there anyway to adjust the delay from when the solenoid clicks until the cart moves. I've seen something before about going into the setting and adjusting the throttle. So any recommendations on what I should adjust.

[orangeman6]

You don’t have to disconnect the controller from the cart. There a port on the controller that allows you to connect it to a laptop. You need a cord like your printer uses. Look on the Alltrax website for the Alltrax toolkit and download it. There’s all sorts of settings in there to customize the way your cart drives, throttle response being one of them.

[scottyb]

There are a few ways to correct a delayed throttle response. You can compress the throttle scale by clicking, dragging, and dropping the upper left corner of the scale to right a bit.
You can increase the start value of the signal by adding an adjustment point at the beginning of the throttle progress line and raising this point so the initial signal higher.