|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
12-10-2009, 06:16 PM | #1 |
Not Yet Wild
Join Date: Oct 2009
Location: NE Arkansas
Posts: 2
|
G9A Will Not Go Forward
G9A will not go forward. It starts when selecter in forward position. It will go in reverse.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-10-2009, 07:39 PM | #2 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,868
|
Re: G9A Will Not Go Forward
Most likely one or both forward reverse cables are bad. They work on a "push/pull" set up, so if one is bound or frozen, they can't move the lever on the transmission. I highly recomend changing both at the same time. Good luck
|
12-30-2009, 07:49 AM | #3 |
Gone Wild
Join Date: Apr 2009
Location: Vegas NV
Posts: 262
|
Re: G9A Will Not Go Forward
I have an identical problem. Whether the F/R lever-handle is placed Forward or Reverse, the cart just moves backwards. My clutch cables just came out of the box.
|
12-30-2009, 12:20 PM | #4 |
Admin
Join Date: Dec 2006
Location: TN
Posts: 101,826
|
Re: G9A Will Not Go Forward
These cables are notorious for seizing up over time. Keep them sprayed with WD40 or some type of penetrating oil, especially back at the trans.
If you've installed new one's and the cart still will not shift right, its more than likely because they are not adjusted properly back at the trans or the bracket that holds the cables is off by a notch or two on the small shifter shaft coming out of the trans. Move the shifter back and forth and watch the shift bracket on the trans to see if it moves fully to the right and left. |
|
|
12-30-2009, 06:27 PM | #5 |
Gone Wild
Join Date: Apr 2009
Location: Vegas NV
Posts: 262
|
Re: G9A Will Not Go Forward
Thank you for the advise. Will work on it today. I just noticed that the lever (in front of the tranny box) just swings one way. i.e clockwise (if you are facing it). Is it possible that the gears inside got stucked somehow?
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Forward Reverse switch melted on forward...have question about replacement part | Electric Club Car | |||
94 ezgo dcs no forward | Electric EZGO | |||
g1 will run in reverse but not forward | Gas Yamaha | |||
No forward | Electric EZGO |