|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
10-19-2017, 03:33 PM | #1 |
Not Yet Wild
Join Date: Apr 2016
Posts: 16
|
G1Oil Pump setting
Ok, have. Yamaha G1 that's was running fine and then quit. Figured it was out of fuel, not sure if that's why it quit but I did put a couple gallons in the tank. Still not running. Great compression as I just replaced piston and ring and had the jug bored. Fuel is pumping through a clean filter and just put on a brand new carb. Great spark with a new plug.
Could the oil pump be bad and putting too much oil in the mix? Could it just need an adjustment? Do the oil pumps need to be adjusted regularly if so what would be the settings? The cart ran great then it just died and won't start. It does fart and will continue to fart but it's just not enough for it to go. Any help is appreciated. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-19-2017, 04:52 PM | #2 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: G1Oil Pump setting
These pumps hardly put out any oil I don't think that is your issue here... Is the spark plug wet or dry after cranking over for awhile?
|
10-19-2017, 05:20 PM | #3 |
Not Yet Wild
Join Date: Apr 2016
Posts: 16
|
Re: G1Oil Pump setting
Wet and the gap is set at .025.
|
10-19-2017, 05:30 PM | #4 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: G1Oil Pump setting
I know you just rebuilt it but throw a compression gauge on it.. if you have compression fuel and spark it should run
|
10-19-2017, 05:45 PM | #5 |
Not Yet Wild
Join Date: Apr 2016
Posts: 16
|
Re: G1Oil Pump setting
I know it's crazy. I am totally stumped. I've got all three and it will fire just not enough to go. Thanks
|
10-19-2017, 06:04 PM | #6 |
Not Yet Wild
Join Date: May 2016
Location: San Diego
Posts: 50
|
Re: G1Oil Pump setting
Pull the new carb off and clean the old stock one. The new China ones are good for a paper weight and that’s about it.
|
10-19-2017, 06:06 PM | #7 |
Gone Wild
Join Date: Jan 2016
Location: FL
Posts: 1,067
|
Re: G1Oil Pump setting
|
10-19-2017, 06:09 PM | #8 |
Gone Wild
Join Date: Jan 2016
Location: FL
Posts: 1,067
|
Re: G1Oil Pump setting
Also just to be sure, make sure your pedal cable is not frayed to the point where you can’t start it. It happens sometimes
|
10-19-2017, 06:20 PM | #9 |
Not Yet Wild
Join Date: Apr 2016
Posts: 16
|
Re: G1Oil Pump setting
The old carb was an after market as well, and it ran very good. Engine does the same with both carbs fires but will not run.
|
10-19-2017, 06:22 PM | #10 |
Not Yet Wild
Join Date: Apr 2016
Posts: 16
|
Re: G1Oil Pump setting
Linkage to carb is good
|
Tags |
fuel/oil mix, not firing, yamaha g1 |
|
|
Similar Threads | ||||
Thread | Forum | |||
G1 gasket for oil pump housing and for oil pump? | Gas Yamaha | |||
g1 new fuel pump still wont pump HELP | Gas Yamaha | |||
Setting toe on a G-16 | Gas Yamaha | |||
re-setting the obc | Electric Club Car | |||
the 27 hp kaw. is setting in the c.c. | Big Block Talk! |