01-24-2012, 07:08 AM | #1 |
Not Yet Wild
Join Date: Dec 2011
Location: GUAM
Posts: 59
|
Stock Dash/Bin Installation
Trying to figure out how to reinstall the stock dash/bin into the frame of my 2000 club car.
Looks like I need to remove the front body and slide in from the front. Yes? Also, the image from one of the threads looks like it is attached with a "special shaped rivet" sold from everythingcarts. Is this the part? Finally, same image shows that it attches in 9 typical places, but I beleive that I have more holes in the two front dash/bins than that. Not sure if the PO put more in. Can someone with info on this please help. I tried to search but could find the info. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-24-2012, 06:58 PM | #2 |
Getting Wild
Join Date: Oct 2010
Location: indy
Posts: 101
|
Re: Stock Dash/Bin Installation
yes, the front body needs to be removed to reinstall dash/bin. the bins are held in with pull rivets , the large bin should have 3 rivets and the small one should have 2 rivets, and both bins have 2 larger holes lower outboard to install drink holders and 1 smaller hole in the top in each bin to install the metal trim and the 2 large lag bolts on top on each end.
|
01-24-2012, 09:05 PM | #3 |
Not Yet Wild
Join Date: Dec 2011
Location: GUAM
Posts: 59
|
Re: Stock Dash/Bin Installation
PERFECT.....
Thank You Much....... |
|
|
Similar Threads | ||||
Thread | Forum | |||
Stock controller and Stock Solenoid from PDS for sale | Golf Carts and Parts | |||
MP3 amp installation | Electric EZGO | |||
Club Car Dash - Lockable Dash Insert Doors for Sale | Golf Carts and Parts | |||
pot box installation | Electric Club Car | |||
How big of a tire on a stock cart with stock rims ? | Electric golf carts |