|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
01-03-2021, 12:04 PM
|
#1 |
|
Not Yet Wild
Join Date: Nov 2020
Posts: 7
|
Precedent Front Bench Seat
I have a 2007 Precedent and am looking for advice on mounting the front bench seat that covers the batteries. The stock setup has two "clips" that you insert into the slots on the battery bucket while holding the seat upright, then rotate the seat down into position. One of my slots on the battery bucket is broken. The plastic part of the slot, not the metal clip part. So now I'm trying to figure out how to manufacture a new way to mount the seat, but still be able to just pivot it on its front edge so I can access the run/tow switch and the batteries. My initial thought is to mount a hinge to the seat that will have a "pin" that will somehow attach to a receiver on the bucket, but wanted to see if anyone has encountered this before and how they fixed it before I try to invent the wheel.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
01-03-2021, 12:41 PM
|
#2 |
|
Gone Wild
Join Date: Jun 2011
Location: Northern Indiana
Posts: 2,823
|
Re: Precedent Front Bench Seat
It's a design flaw as far as I'm concerned. It's very rare that I see a Precedent that has NOT broken out at least one of those hinge pockets. If you're content with bolting something to the body, maybe something like these hinges that were used on some of the Chinese clone carts.
|
|
|
|
|
01-03-2021, 12:45 PM
|
#3 |
|
Not Yet Wild
Join Date: Nov 2020
Posts: 7
|
Re: Precedent Front Bench Seat
I'm completely fine with bolting to the body. Was actually considering something just like that, but adding a pin to it so it would just slide down into the body side.
|
|
|
|
|
01-03-2021, 12:56 PM
|
#4 |
|
Gone Wild
 Join Date: Jun 2018
Location: Richmond,Virginia
Posts: 547
|
Re: Precedent Front Bench Seat
52F7CF0B-1577-4F36-BBAB-88A2FD677190.jpg. This may help.
|
|
|
|
|
01-03-2021, 01:01 PM
|
#5 |
|
Not Yet Wild
Join Date: Nov 2020
Posts: 7
|
Re: Precedent Front Bench Seat
Sweet! That's perfect. Thank you so much.
|
|
|
|
|
01-03-2021, 09:09 PM
|
#6 |
|
Gone Wild
Join Date: May 2016
Location: Raleigh, NC
Posts: 194
|
Re: Precedent Front Bench Seat
That metal plate was stock on my '14 so I guess they realized there was an issue and that is what they did to fix it.
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| G-1 Bench seat ideas | Gas Yamaha | |||
| Bench seat | Golf Carts and Parts | |||
| G1 bench seat build | Gas Yamaha | |||
| What Bench Seat For G1 | Gas Yamaha | |||
| WTB Precedent Roof and Front seat | Golf Carts and Parts | |||
Linear Mode
