steering unit

justnjoett@aol.com · 03-08-2018, 04:41 PM

need to replace the outer rack ball end located at the end of the steel circular bar that runs thru the steering unit itself..NOT the tie rod ends.this ball joint with the grease nipple appears to be connected via a 17mm nut..with the ball joint shaft going into this 17mm nut..cant seem to loosen either..any ideas on how to remove this outer rack ball end..Cheers...John

meimk · 03-08-2018, 06:55 PM

Can't loosen? Does the nut and the stud spin together? There should be a thin hex - I think 14 mm, on the stud just beyond the bar it goes through.

03-08-2018, 04:41 PM	#1
justnjoett@aol.com Not Yet Wild Join Date: Feb 2018 Posts: 9	steering unit need to replace the outer rack ball end located at the end of the steel circular bar that runs thru the steering unit itself..NOT the tie rod ends.this ball joint with the grease nipple appears to be connected via a 17mm nut..with the ball joint shaft going into this 17mm nut..cant seem to loosen either..any ideas on how to remove this outer rack ball end..Cheers...John

03-08-2018, 06:55 PM	#2
meimk Gone Wild Join Date: Jun 2011 Location: Northern Indiana Posts: 2,823	Re: steering unit Can't loosen? Does the nut and the stud spin together? There should be a thin hex - I think 14 mm, on the stud just beyond the bar it goes through.

Similar Threads
Thread	Forum
CDI unit on g1a blowing	Gas Yamaha
What head unit to get?	Electric EZGO
Control unit	Gas EZGO
1992 Club Car DS Steering Unit and Tie Rods	Electric Club Car
Speed unit	Electric Club Car

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum